Lighting Controls

HDR



Product Bar End
Product Bar End

HDR

HDR(2)

WattStopper Low voltage relay for control of lighting circuits and other electrical loads

 

This low voltage relay is used for control of lighting circuits and other electrical loads. Momentary, low voltage pulses from the panels control system switch the relays on or off. Mechanical latching operation results in lower power consumption. The relay will remain in the last switched state in the event of a power loss. A manual override switch allows lights to be turned on in the event of a panel or relay failure. The relay mounts into a standard knockout and comes with a pluggable cable for easy panel connection. Direct replacement relay for Watt Stoppers Lighting Integrator control panels.


Products

(Wholesale customers, log in for your special pricing)

QtyModelDescriptionIn StockList PriceInternet Price
HDR RELAY (5 WIRE) WITH OVERRIDE & CONNECTOR In Stock101.6481.31

Accessories

QtyModelDescriptionIn StockList PriceInternet Price
RR-BRACKET-4 RR-7/RR-9 4-HOLE BRACKET In Stock17.9414.35
Features
  • Integral manual override
  • Suitable for use with all HID ballasted loads
  • Expected service life is over 25 years at nominal load and cycle rate
  • Manual override switch
  • 5-pin pluggable connection
Specifications

Mounting:Standard 1/2 knockout mounting

Wire gauge:Accepts wire gauge #10 - #14 AWG, copper wire, solid or stranded

Operating voltage:24 VDC

Pilot contacts:Isolated pilot relay contacts, 0.5 Amp @ 30 VAC/DC for status feedback

Ballast load:30 Amp @ 277 VAC (including HID) 20 Amp @ 347 VAC

Tungsten load:20 Amp @ 120 VAC

Resistive load:30 Amp @ 347 VAC

Motor load:1-1/2 HP @ 120 VAC

Short circuit:Rated 14,000 amps Short Circuit Current Rating (SCCR)

Dimensions:3.2" x 1.3" x 0.85" (81.3 x 33.0 x 21.6 cm)

Approvals:UL listed E258542, CSA certified

Warranty:5 years

Download Additional Data


                                    document
                                  Catalog Page