NEMA 1 UL (plenum rated) enclosure: Suitable for stand-alone applications.

Ease of Programming: Use the easy programming dial, an optional hand-held parameter unit (FR-PU07) or programming/ configuration software (FR-configuration).

Windmill Start: F700 measures residual motor slot ripple to determine both the speed and direction in rotation of a coasting motor, bringing it under control swiftly and smoothly when required - regardless of whichever way it's spinning.

Enhanced Energy Savings: An improved version of Mitsubishi Electric's famous energy-optimization software boosts motor efficiency to unprecedented levels and intelligently maximizes energy savings.

Power Dip Ride-Through: Allows the inverter to continue to run during short power supply interruptions - reducing nuisance tripping.

Overvoltage Avoidance: The F700 measures DC bus levels when decelerating and controls drive speed to eliminate nuisance tripping.

Remote I/O Capability: Drive I/O can be configured over a network to work independently of the drive, reducing cost and making more efficient use of the available network nodes.

Independent RS-485 Connections: Allow serial communications and keypad operation at the same time with no options needed. F700 supports Modbus RTU as well as the standard Mitsubishi Electric protocol. 

Voltage:3 phase, 170-528 VAC

Motor rating:1.0 to 250 hp

Acceleration/ deceleration time:0-3600 seconds

Starting Torque:120% 3Hz

Output Frequency Range:0.5 to 400Hz

Operating Temperature:14 deg to 122 deg F (-10 deg to 50 deg C)                     

Frequency Setting:

  Analog Input:3 terminals, 0 to 10V, 0 to 5V, 4 to 20mA; -10 to + 10V, -5 to 5V

  Digital Input:Four digit  BCD or 16 bit binary

Current:0-20 or 4-20 mA

Max load:Impedance: 250 ohms 

Digital inputs:12

Analog outputs:2

Digital output:5

Relay output:2

Communication ports:2

Communication interface options:Lon works, N2, Modbus, Device Net, BACnet, Profibus

Warranty:3 years